Les études expérimentales ainsi que numériques ont mis en évidence la contribution importante des effets intrabandes à la dynamique du gain lorsque des SOA sont saturés par des impulsions courtes (quelques picosecondes).
Dans cette thèse, il a été démontré que le SOA massif à fort confinement et le SOA ultra-long à boîtes quantiques sont les plus adaptés pour un fonctionnement à 40 Gbit/s avec des temps de récupération du gain respectivement de 20 ps et 10 ps. L'expérience pompe sonde permettant mesurer le temps de récupération du gain a été réalisée pour étudier la dynamique des SOA. La première partie des travaux a été consacrée entièrement aux portes optiques non linéaires à base des SOA pour des applications à la régénération 2R. Concernant la fonction de resynchronisation, différentes récupérations d'horloge tout optiques ont été étudiées dans cette thèse. La dynamique ultrarapide du gain des amplificateurs optiques à semiconducteur (SOA) est étudiée afin de l'exploiter pour développer des fonctions simples et compactes permettant la remise en forme du signal. L'objectif de cette thèse est de développer des portes optiques non linéaires et d'explorer des méthodes de récupération d'horloge optiques, toutes à base des semiconducteurs, pour la régénération tout optique de signaux à un débit égal ou supérieur à 40 Gbit/. A partir de 40 Gbit/s, le traitement tout optique du signal peut offrir une solution intéressante pour réduire la consommation ainsi que le coût des systèmes optiques du futur. (C) 2009 Alcatel-Lucent.įace à l'augmentation constante du trafic lié notamment à Internet, la demande de capacité dans les réseaux cœur ne cesse de croitre : le débit par canal des systèmes WDM a atteint 40 Gbit/s et va bientôt atteindre 100 Gbit/s. Finally, we demonstrate that, owing to the very wide and flat optical spectrum and the low relative-intensity noise level of the mode-locked laser, error-free transmission over 50 km single mode fiber has been achieved for eight wavelength division multiplexing ITU channels at 10 Gb/s with a channel spacing of 100 GHz. They can also be used to achieve all-optical clock recovery, with timing jitter compliant with International Telecommunication Union (ITU) standards even for highly degraded input optical signal-to-noise ratio. We will demonstrate that these quantum dash lasers can be actively mode-locked, generating sub-picosecond or picosecond pulses at different repetition frequencies with extremely low timing jitter. In particular, we will describe the quantum dash nanostructures used for the mode-locked lasers and the dependence of the mode-locking properties on detailed quantum dash structures. This paper will report on new advances in InP-based quantum dash mode-locked lasers, which largely surpass the performance of their bulk or quantum well counterparts in terms of the mode-beating spectral purity and the bandwidth of optical spectrum. Several applications are pushing the development of high performance mode-locked lasers: generation of short pulses for extremely high bit rate transmission at 100 Gb/s and beyond, all-optical clock recovery at 40 Gb/s and beyond, generation of millimeter wave signals through mode-beating on a high speed photodiode, optical sampling for analog-to-digital conversion, and generation of wavelength-division-multiplexing channels. This study allows an in-depth study of this simple and frequently used OCR configuration, and outlines some limitations of the technique, linked to the compatibility between the finesse of the FPF, the pattern length, and the general optical communication system properties. Second, we experimentally study the sensitivity of the OCR to the incoming pattern length using phase noise and bit-error-rate measurements in an optical communication system environment. The impact of each component of the clock recovery process is clearly observable via the quality of the remodulated clock. Then we perform two studies in order to explore the dependency of the RCK on patterning effects: first, we carry out a numerical simulation of the tandem filter and amplifier, in order to study its performance as an OCR process. The recovered clock (RCK) quality relies on an original technique based on the remodulation by the optical clock with electrical data. A 40-GHz optical clock is then recovered from an optical data stream at 40 Gbit/s.
For this analysis, we use a commercial Fabry-Perot filter (FPF) in front of a semiconductor optical amplifier. In this paper, we present a complete study of the pattern sequence length influence in the optical clock recovery (OCR) process using passive filtering.